oil type SUZUKI GRAND VITARA 2008 3.G Inspection And Maintenance Manual

Downloaded from www.Manualslib.com manuals search engine EXAMPLE
520084
It is important to keep the engine oil at the
correct level for proper lubrica.tionof your vehicle's engine. Check the oil level with
the vehicle on a level surface. The oil level indication may be inaccurate if the vehicle is on a slope. The oil level should be checked either before starting the engine
or warm up the engine to normal operating
temperature, then stop the engine and wait
at least 5 minutes (at least 10 minutes for Diesel engine model).
The handle of the engine oil dipstick is col­ored yellow for easy identification. Pull out
the oil dipstick, wipe oil off with a clean cloth, insert the dipstick all the way into the
engine (for cap-type dipstick, screw in it fully), then remove it again. The oil on the
stick should be between the upper and lower limits shown on the stick. If the oil level indication is near the lower limit, add
enough oil to raise the level to the upper limit.
CAUTION
Failure to check the oil level regularly could lead to serious engine trouble due to insufficient oil.
CAUTION
(For Diesel Engine Model)
• Do not top up the oil over the upper limit. Too much oil could destroy
the engine.
• For cap-type dipstick, screw in it fully to check the engine oil. Other­wise, the stick does not show the correct level, and the engine oil
may be filled over the upper limit.
INSPECTION AND MAINTENANCE
Refilling
EXAMPLE
81A147
Remove the oil filler cap and pour oil slowly through the filler hole to bring the oil level to the upper limit on the dipstick. Be careful not to overfill. Too much oil is almost as bad as too little oil. After refilling, start the
engine and allow it to idle for about a
minute. Stop the.engine, wait about 5 min­utes and check the oil level again.
7-10

Downloaded from www.Manualslib.com manuals search engine Selection of Coolant CAUTION
SUZUKI LLC: Super (Blue) coolant;
SUZUKI LLC: Super (Blue) coolant is already diluted to the proper percent­
age. Do not dilute with distilled water additionally. Doing so may result in the possibility of freezing coolant and/or overheating.
To maintain optimum performance and durability of your engine, use SUZUKI Genuine Coolant or equivalent.
NOTE: If you replace the engine coolant other
than the SUZUKIl:.LC: Super (Blue), follow
.the schedule of SUZUKI LLC: Standard
(Green). To see the detail of the mainte­nance schedule, refer to "Periodic Mainte­nance Schedule" in this section.
This type of coolant is best for your cooling system as it: • Helps maintain proper engine tempera­ture. • Gives proper protection against freezing
and boiling.
• Gives proper protection against corro-
sion and rust. Failure to use the proper coolant can dam­age your cooling system. Your authorized SUZUKI dealer can help you select the
proper coolant.
CAUTION
To avoid damaging your cooling sys­tem: • Always use a high quality ethylene
glycol base non-silicate type cool­ant diluted with distilled water at the correct mixture concentration. • Make sure that the proper mix is 50/ 50 coolant to distilled water and in no case higher than 70/30. Concen­trations greater than 70/30 coolant to distilled water will cause over­heating conditions. • Do not use straight coolant nor plain water (except SUZUKI LLC: Super (Blue».
• Do not add extra inhibitors or addi­tives. They may not be compatible with your cooling system. • Do not mix different types of base coolants. Doing so may result in accelerated seal wear and/or the possibility of severe overheating and extensive engine/automatic
transmission damage.
INSPECTION AND MAINTENANCE
Coolant Level
Check Check the coolant level at the reservoir
tank, not at the radiator. With the engine cool, the coolant level should be between
the "FULL (MAXI)" and "LOW (MINI)" marks.
Adding Coolant
(For Gasoline Engine Model) If the coolant level is below the "LOW" mark, more coolant should be added. Remove the reservoir tank cap and add coolant until the reservoir tank level reaches the "FULt..:' mark. Never fill the res­ervoir tank above the "FULt..:' mark.
(For
Diesel Engine Model)
A. WARNING
It is hazardous to remove the degas­sing tank cap for Diesel engine when the water temperature is high,
because scalding fluid and steam may be blown out under pressure. Wait· until the coolant temperature has lowered before removing the cap.
If the coolant level is below the "MINI" mark, more coolant should be added. When the engine is cool, remove the degassing tank cap by turning it antic lock­wise slowly to release any pressure. And add coolant until the degassing tank level reaches the "MAXI" mark. Never fill the
degassing tank above the "MAXI" mark.
7-14

Downloaded from www.Manualslib.com manuals search engine INSPECTION AND MAINTENANCE
Spark Plugs
78K056
NOTE: For 3.2 L engine, to approach the spark
plugs, you need to remove the bolts shown in the illustration.
7-17
Type A
(1 )
65D434
For Type A, to access the spark plugs: 1) Remove the ignition coil cover. 2) Disconnect the coupler (1) while push­
ing the release lever. 3) Remove the bolt. 4) Pull the ignition coil out.
Type B
(2)
65D435
For Type B, to access the spark plugs: 1) Disconnect the coupler (2) while push-
ing the release lever. 2) Remove the bolts. 3) Pull the spark plug boots out.
NOTE: When installation, make sure the wires, couplers, sealing rubber of top cover and
washers, are correctly returned in place.

Downloaded from www.Manualslib.com manuals search engine INSPECTION AND MAINTENANCE
Spark plug gap "a" IFR5J11/1FR6J11/SILFR6A11/41-990 1.0 -1.1 mm (0.039 -0.043 in.)
CAUTION
When replacing spark plugs, you should use the brand and type speci­fied for your vehicle. For the speci­fied plugs, refer to the "SPECIFICATIONS" section at the
end of this book. If you wish to use a
brand of spark plug other than the
specified plugs, consult your SUZUKI
dealer.
7-19
Gear Oil
Manual Transmission OillTransfer
Oil/Differential Oil
650259
When adding gear oil, use gear oil with the
appropriate viscosity and grade as shown
in the chart below. We highly recommend you use: API GL-4 SAE 75W-90 for manual trans­mission gear oil API GL-5 hypoid gear oil SAE 80W-90 for
front differential oil, rear differential oil and
transfer gear oil
Manual transmission oil (API GL-4)
< 75W-85,75W 90 > °C -30 -20 -10
0 10 20 30 40 I I I I . . I I of -22 -4
14 32 50 68 86 104
650571
Front differential oil,
rear differential oil and transfer oil (API GL-5 hypoid)
90 >
< 80W
90 > °C -30 -20 -10 0
10 20 30 40 I
I I I
I I I
I 'F -22 -4
14 32 50 68 86 104
650572

Downloaded from www.Manualslib.com manuals search engine INSPECTION AND MAINTENANCE
the oil level reaches the bottom of the Clutch Pedal filler hole, then reinstall the plug.
.A WARNING
After driving the vehicle, the gear oil
temperature may be high enough to
burn you. Wait until the oil filler
plug is cool enough to touch with your W\\N bare hands before inspecting gear
oil.
CAUTION
When tightening the plug, apply seal­ing compound "SUZUKI Bond No. 1215" or equivalent to the plug threads to prevent oil leakage.
Gear Oil Change To change the gear oil in the manual trans­mission, transfer case or differential(s), use
the following procedure:
1) Remove the oil filler plug (1). 2) Remove the drain plug (2), drain the oil, and reinstall the drain plug. 3) Pour new gear oil of the specified 'type
through the filler hole until the oil level reaches the bottom of the filler hole. 4) Reinstall the filler plug.
7-21
64J154
Check the clutch pedal for smooth opera­tion and clutch fluid level from time to time. If clutch dragging is felt with the pedal fully depressed, have the clutch inspected by
your SUZUKI dealer. If the clutch fluid level is near the "MIN" line, fill it up to the "MAX"
line with SAE J1703 or DOT-3 brake fluid.
Automatic Transmission (AT)
Fluid
Specified Fluid Use an automatic transmission fluid
SUZUKI ATF 3317 or Mobil ATF 3309.
Fluid Level Check
CAUTION
Driving with too much or too little
fluid can damage the transmission.
You must check the fluid level with the
automatic transmission fluid at normal operating temperature.
To check the fluid level: 1) To warm up the transmission fluid, drive
the vehicle or idle the engine until the
temperature gauge indicates normal operating temperature. 2) Then drive for ten more minutes.
CAUTION
Be sure to use the specified auto­matic transmission fluid. Using auto­matic transmission fluid other than SUZUKI ATF 3317 or Mobil ATF 3309 may damage the automatic transmis­sion of your vehicle.